ML10

Locking nuts to fit the tailstock clamping stud and to secure the tailstock handwheel
Thread: 3/8" B.S.F
Finish: Bright zinc plate
Unit Quantity: Pack ...

Replacement oil nipples used throughout Myford lathesFlat front face and spherical rear form permits use with all types of push fit oil guns These nipples have ...

Myford reference: Woodruf Key No. 404Used throughout Myford lathesSize: ½" x ⅛"Quantity: Pack of 5Application: ML7; ML-7R; ML10; Super 7Category: New_Item...

Standard Vee-Belt which drives from the 3-step pulley on the countershaft to the headstock spindle drive pulley.High quality belt from a major supplierApplicati...

Standard Vee-Belt which drives from the motor pulley to the counter-shaft drive pulley.Application: ML10 – not Speed 10 or Diamond 10Category: New_Items...

Standard Vee-Belt which drives from the motor pulley to the counter-shaft drive pulley.High quality belt from a major manufacturerApplication: Speed 10; Diamond...

Oil Gun for Myford LathePump type high pressure oil gun.· Primarily intended for use on Myford ML7, Super Seven and ML10 lathes although these guns would be sui...

Myford Part No. 86
Set of 4 faceplate clamps
Length: 2 1/2"
They are suitable for clamping work not only to the faceplate but also to the cross slide a...

Set of 4 faceplate clamps - similar to Myford ones
Length: 2 1/2"
They are suitable for clamping work not only to the faceplate but also to the cross ...

Myford Part No. 1438Collet Nose Piece enables Myford MT2 Collets (11445) to be fitted directly into the headstock spindleCondition: 9/10Application: ML7; ML-7R;...

Myford Part No. 1439 (2MT Collets) Collet Closing Tube comprises 11446 Extractor Sleeve and14367 Extractor. This device is intended for closing the collet to si...

Myford 2 MT Collets fit directly into the spindle of all ML10, Speed 10, Diamond 10, ML7, ML7-R and Super 7 lathes, with spindle nose bored 2 MT and threaded 1....

Myford 2 MT Collets fit directly into the spindle of all ML10, Speed 10, Diamond 10, ML7, ML7-R and Super 7 lathes, with spindle nose bored 2 MT and threaded 1....

Myford 2 MT Collets fit directly into the spindle of all ML10, Speed 10, Diamond 10, ML7, ML7-R and Super 7 lathes, with spindle nose bored 2 MT and threaded 1....

Myford 2 MT Collets fit directly into the spindle of all ML10, Speed 10, Diamond 10, ML7, ML7-R and Super 7 lathes, with spindle nose bored 2 MT and threaded 1....

Myford 2 MT Collets fit directly into the spindle of all ML10, Speed 10, Diamond 10, ML7, ML7-R and Super 7 lathes, with spindle nose bored 2 MT and threaded 1....